GPM
From dirty water to 70% solids, GPM’s submersible pumps are engineered to provide many years of trouble-free service.
- Submersible Pumps
- these come standard with the following features:
- 28% high-chrome, 650+ Brinell hardness wet-end materials
- Dual SiC vs. SiC mechanical seals
- Inverter duty motor, Class H (180°C) winding insulation
- Casing sprayholes for slurry agitation
- 33′ Cable
- 416SS shaft construction
- these come standard with the following features:
- Submersible Mixers
- Dewatering Pumps
- Extended Shaft Pumps
- Horizontal Pumps
- Vertical Pumps
- Explosion Proof Pumps
FEATURES
- GPM-Eliminators can be 5HP to 800HP.
- Uses mechanical seals
- Oversized pump shafts to decrease shaft deflection and increase mechanical seal life.
VIKING
CENTRIFUGAL PUMP
- Non-clogging impeller extra heavy vanes.
- Semi-open design allows passing of foreign material and the handling of clean or dirty liquids.
- Impeller is statically and hydraulically balanced.
- High tensile steel shaft machined to ensure proper fit of impeller and bearings.
- Vertically split casing design.
- Discharge may be rotated every 45 degrees from regular top vertical position to facilitate piping.
- Designed for 150 PSI maximum working pressure.
- Axial Shaft Adjustment permits impeller to be adjusted for end clearance, maintaining pumping efficiency at all times.
- Shaft adjustment nut prevents any forward axial movement of impeller during pump operation.
- Mechanical seals: Buna-N, Viton, and PTFE are available as an optional feature.
- Bearings: heavy duty, ball type, grease lubricated.
- Bearing housing has integral support foot for accurate, permanent alignment of bearings and rigid support of shaft.
Recent Comments